Forum Replies Created

  • milouchan7065

    Member
    May 6, 2020 at 4:56 pm in reply to: Xstage Lite set up

    It does this when it’s on static mode. I’ve turned the X screws as far as they can go. All the other 3 screws on the base and the slanted part are also as tight as they’ll go. I’m not sure if it’s “normal” for the A pole to twist/rotate a bit when it’s on static mode. It was initially not moving but when I’ve used it for a bit (on static mode) the X screws seem to loosen. Wondering if this is normal and happens to other xstage owners?

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .