-
Lil Mynx pole on carpet or hard flooring?
-
The little feet can be purchased at home depot or lowes.
-
I have an Xpole that is pressure mounted and what I did to be extra careful it will NEVER fall is I took two sheets of plywood, cut the size of the top plate in one of the sheets (we used a jig saw so you will have to find someone handy with wood working and make sure the cutout is as close to the size of the top base as you can to prevent any side to side movement), than we both glued and screwed the two boards together one on top of the other. I than painted it to match my ceiling (it is in my living room so I wanted it to look decent!) I than took two lag bolts and screwed the board to the ceiling joist.
The total size of the layered boards for my pole which has about a 16 inch diameter is about a foot and a half by two feet ish and the plywood is half inch. When you mount your pole up u slip it into the cut out in the plywood, tighten it down and than you are for sure safe cause you have that extra half inch of space that if the pole moves you will notice and tighten it up before you fall.
Good luck with whatever you decide to do! 🙂
-
When you gals are using the ‘non skid pad’ for hardwood floor or whatnot, do you have the little feet on the bottom of the pole as well? or are you using the pad as a replacement of those? There’s no information about it. Thanks in advance!
-
Nevermind! I FINALLY found a picture of it being used properly.
Log in to reply.