-
Pole not spinning as well as before?
Hello there!
How is everyone? https://www.studioveena.com/img/smilies/icon_e_smile.gif
Hey I’ve had my x pole a little while, then i took it down to take it to a friends place and when I put it up there it didnt spin that well anymore. And now I’ve brought it back home it still doesnt spin very well. It kinda ‘sticks’ when you spin it with your hands. With your body wight on it it’s probably a bit better because its a bit slower and you dont have to chunder as much https://www.studioveena.com/img/smilies/icon_razz.gif but yeah just wondering if you think I may have it done too tight or if I need to oil it or something?
https://www.studioveena.com/img/smilies/icon_e_smile.gif
xxx
-
4 Replies
-
If you over tighten your pole this can https://www.studioveena.com/img/smilies/icon_flower.gif happen…..
-
Ah you’re a genius!
I loosened it and magically it spins at chunder speed again! https://www.studioveena.com/img/smilies/icon_razz.gif
xxx
-
Yippy!! I have done that before….now to make sure I haven’t over tightened my poles I always put the pole on spin and turn it with my hands…if its not smooth I know its too tight. I’m glad its all better https://www.studioveena.com/img/smilies/icon_cheers.gif
-
Aha!! https://www.studioveena.com/img/smilies/icon_exclaim.gif https://www.studioveena.com/img/smilies/icon_exclaim.gif https://www.studioveena.com/img/smilies/icon_exclaim.gif
I think I need to loosen my pole, too, ’cause I have the same problem.
I think my floor gives in a bit, I have a little trouble figuring out when to stop…
I kept tightening it because otherwise it unscrews when I go couterclockwise, even though the locking nut on top is tight.
Any idea how to avoid the unscrewing without over-tightening???
Log in to reply.
