Forum Replies Created

  • lar874717

    Member
    May 31, 2016 at 10:08 pm in reply to: hex crew in xjoiner

    I have seen them in the hardware store, but they are plain grub screws with only one thread, the one that I have removed from the xjoint (nJ) is a 30mm with opposite treads on each end and stop in the middle it, as I have the older model xs pole, is it ok to use the normal grub screw with 1 thread?

    Also dose anyone know what the other 4 x little screws name and model are called to replace them ? I know there some kind of safety screw

    TIA

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .